Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Reset the Tyre Pressure Light on the Renault Captur

Model: Renault Captur MK 2 - Years 2019-2026
Part:

To reset the tyre pressure on the 2021-2022 Renault Captur, the procedure is very simple and quick. No tools are required, and the entire operation will take one or two minutes at most. The procedure is as follows: first, turn on the ignition without starting the engine. Then, use the down arrow button to scroll to the "tyre pressure long-term pressure" option. Press and hold the OK button until the message "operation completed" appears. At this point, the reset has been successfully completed.

Updated on 27 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Reset the Tyre Pressure Light on the Renault Captur?
How to Reset the Tyre Pressure Light on the Renault Captur?
Renault Captur (2013-2019 / MK 1) .. In this tutorial, we will see how to reset the tyre pressure light on the Renault Captur, a very simple and quick operation that should.. …
How to Reset the Tyre Pressure Light on a Renault Captur
How to Reset the Tyre Pressure Light on a Renault Captur
Renault Captur (2013-2019 / MK 1) Before starting, adjust the tyre pressures, then sit in the driver's seat and activate the instrument panel of your Renault Captur. Begin by repeated…
How to Reset the Tyre Pressure Light on the Renault Captur?
How to Reset the Tyre Pressure Light on the Renault Captur?
Renault Captur (2013-2019 / MK 1) .. In this tutorial, we will see how to reset the tyre pressure light on the Renault Captur, a very simple operation to perform only after.. …

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos