Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Renault
    3. :
  3. Clio
    4. : License plate light replacement instructions

Renault Clio - Video tutorial

Model: Renault Clio Clio 2, MK 2 - Years 1998-2005
Part: License plate light
Operation: License plate light replacement instructions

The license plate light is located right in the center of the bumper and replacing it is really very simple; given its position, however, it is not certain that the bulb is burnt out, it could in fact also be due to oxidation of the contacts. Therefore, use a small screwdriver to extract the lamp holder and, keeping the lights on, try to move the connector: if the lamp turns on then it is certain that the problem is in the contacts of the power socket; turn off the lights, unplug the socket and clean it with contact spray; reconnect everything, turn on the lights and check that even if the connector is pressed, the light bulb does not go out.


Posted on 7 August 2023 by ScegliAuto



Renault Clio 3 license plate light replacement
Renault Clio (2005-2013 / MK 3, Clio 3, Clio III) Let's see how to replace the license plate lights of a Renault Clio third series, following these simple instructions. First we are going to remove t
How to change the license plate light bulbs on the Renault Clio IV.
Renault Clio (2012-2019 / Clio IV, Clio 4, MK 4) In this video, we see how to change the license plate light on a Renault Clio IV; we will replace the old yellow light bulbs with bright white LED bu
Clio license plate light replacement
Renault Clio (1998-2005 / Clio 2, MK 2) Let's see how to replace the bulb that illuminates the Renault Clio license plate. The spotlight of the license plate is placed in the rear bumper, l

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos