Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Renault
    3. :
  3. Clio
    4. : How to solve the problem of noise inside the Renault Clio IV.

Renault Clio - Video tutorial

Model: Renault Clio MK 4, Clio IV, Clio 4 - Years 2012-2019
Part: Bodywork
Operation: How to solve the problem of noise inside the Renault Clio IV.

In this video, we see how to solve the extremely annoying problem of the rustling noise that can be heard inside the Renault Clio IV version. This is caused by the seals of the deflectors not holding well, and the only solution is to add a thickness, but not with the inner seal (in fact, the situation worsens), but with the outer one. In this video, our YouTuber shows us how to do it: we take a measurement with adhesive tape and fold it in two or three times until we create a small strip (but we can also do it with foam rubber) and repeat to create the right thickness. We open the window and insert it starting from the top, into the seal. We raise the window and test the rustling noise again. Much better, and zero expense.


Posted on 25 December 2023 by ScegliAuto

    Frequently Asked Questions

    • Clio 2005-2013 - What to do when the fuel cap of the Renault Clio does not open? Read Answer
    • Clio 2005-2013 - How to unlock the fuel flap of Renault Clio 3? Read Answer
    • Clio 2012-2019 - What to do when the tailgate of the Renault Clio does not open? Read Answer
    • Clio 2012-2019 - Where is the inertia switch of the 2012 Renault Clio? Read Answer
    • Clio 2005-2013 - Where is the inertia switch of the Renault Clio III? Read Answer
    • Clio 2012-2019 - Where is the horn of the Renault Clio located? Read Answer

How to reset the service in the Opel Antara?

As we can see in this tutorial, resetting the service in the Opel Antara is an extremely simple and fast operation. Before proceeding, of course, we must have completed all the planned maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel, not the engine. At this point, we release the accelerator and press it 3 consecutive times, always all the way. We then restart the panel to verify that the procedure has been carried out correctly.

Watch the video!


by ScegliAuto

More videos