|
Do it yourself
| |||
| ||||
Model: Sherco Sef 300
To map the engine of the Sherco SEF 300, you need to loosen the screws that secure the seat and those that secure the side panels of the bike. Once these parts are loosened, you can remove them by disconnecting the battery power cable; then connect the scanner to the bike's ECU port to perform the mapping following the operations shown in the tutorial. After the operation is complete, disconnect the scanner and reassemble all the removed parts.
Updated on 17 May 2026 by ScegliAuto
Video tutorial
Related tutorials
Sef 300
Here are the instructions on how to carry out the routine maintenance service by replacing the engine oil and oil filter on the Sherco SEF 300 enduro…
Sef 300
To replace the spark plug on a Sherco SEF 300, completely remove the seat of the bike to access the components underneath. Here, you will locate the …
Sef 300
In order to replace the exhaust of the Sherco SEF 300, you need to loosen the screws that secure the panel located on the rear side of the motorcycle…
|
How to Top Up the Oil in the Aprilia SR 50 R Scooter?
In this tutorial, you will see how to top up the oil in the Aprilia SR 50 R scooter, a very simple and quick operation to perform periodically. First, open the small lower compartment and retrieve the supplied tools, then remove the screws securing the front panel located at the back. Once removed, locate the oil reservoir, which is on your left, and unscrew the cap. At this point, proceed to top up the oil until you reach the optimal level, then reassemble everything by following the reverse procedure. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.005
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |