Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To replace the starter motor on a Sherco SEF 300, locate this component, which is found at the lower front part of the frame. Once located, loosen the screws that secure it in place, then disconnect the appropriate connectors. After the old unit is freed, remove the old starter motor and insert the new replacement part. Once installed, verify that everything functions correctly.

Updated on 15 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the muffler of the Sherco SEF 300?
How do you replace the muffler of the Sherco SEF 300?
Sef 300 In order to replace the exhaust of the Sherco SEF 300, you need to loosen the screws that secure the panel located on the rear side of the motorcycle…
How do you replace the fuel filter of the Sherco SEF 300?
How do you replace the fuel filter of the Sherco SEF 300?
Sef 300 In order to replace the fuel filter of the Sherco SEF 300, you need to locate the fuel passage conduit where the fuel filter is located: this will be…
How to Replace the Spark Plug on a Sherco SEF 300
How to Replace the Spark Plug on a Sherco SEF 300
Sef 300 To replace the spark plug on a Sherco SEF 300, completely remove the seat of the bike to access the components underneath. Here, you will locate the …

How to Service the Piaggio Vespa GTS 300

This brief guide will illustrate the main steps to perform the routine maintenance service on the Piaggio Vespa GTS 300, replacing the engine oil and oil filter. First, place the scooter on the centre stand and start by unscrewing the oil drain bolt found under the engine, allowing it to drain into a container for about ten minutes; then unscrew the oil filter cartridge using the appropriate tool, and hand-tighten the new one. Finally, unscrew the filler cap and top up, filling to the maximum level mark!

Watch the video!


by ScegliAuto

More videos