Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Sherco Se 300
Part: Fuel pump

To replace the fuel hose on the Sherco SE 300, insert the key into the designated lock located at the rear of the seat: once the key is inserted, turn it to remove the seat from its position, giving access to the components underneath. At the front, you will find the fuel pump connected to the designated hose: this hose must be disconnected and then completely removed. You can then connect the new hose to the pump, covering everything with the seat that was removed earlier.

Updated on 11 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Install the Exhaust Pipe Guard on the Sherco SE 300?
How to Install the Exhaust Pipe Guard on the Sherco SE 300?
Se 300 To install the exhaust pipe guard on the Sherco SE 300, position the structure at the front of the pipe, located immediately behind the front wheel. …
How to Replace the Exhaust Silencer on a Sherco SE 300?
How to Replace the Exhaust Silencer on a Sherco SE 300?
Se 300 To replace the exhaust silencer on the Sherco SE 300, first remove the right side panel, under which you will find the support for the upper part of …
How do you replace the exhaust pipe of the Sherco SE 300?
How do you replace the exhaust pipe of the Sherco SE 300?
Se 300 In order to replace the exhaust pipe of the Sherco SE 300, you need to loosen the screws that attach the side panel of the motorcycle, so that you ca…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos