Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Sherco
    3. : Ser 250

How to remove the starter motor from the Sherco SER 250?

Model: Sherco Ser 250
Part: Starter motor

Video tutorial

To remove the starter motor from the Sherco SER 250, first remove it from its housing by unscrewing the screws that secure it and disconnecting the connectors. Once the motor has been removed, you can loosen the screws that secure the device's cover to gain access to the components inside.

At this point, you can completely remove them, allowing you to insert the new ones, close the device again, and reconnect it properly in its place.


Updated on 30 August 2026 by ScegliAuto


Related tutorials

Removing the Starter Gear of a Sherco SER 250
Removing the Starter Gear of a Sherco SER 250
Ser 250 In this video, you will find instructions on how to remove the starter gear of a Sherco SER 250 and 300. First, unscrew the screws of the starter cov…

How to Set the Time on a Kymco DTX360?

To set the time on a Kymco DTX360, follow these steps. First, turn on the scooter and ensure it is in time display mode on the dashboard. Once you find this mode, press and hold the button for setting the time, located on the scooter's handlebars. After a few seconds, the display will start to flash, indicating that you can now adjust the time. Use the adjustment buttons to increase or decrease the hour until you reach the desired time. When you have set the correct time, press the time setting button again to confirm your selection. The display will stop flashing and the time will be set correctly. Be sure to consult the owner's manual for specific instructions for your Kymco DTX360 model, as the procedure may vary slightly.

Watch the video!


by ScegliAuto

More videos