Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Dismantle the Actuator on the Smart Fortwo 451

Model: Smart Smart 451 - Years: 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015
Part: Transmission

See other generations:
Video tutorial

If you want to carry out a revision of the gearbox actuator on your vehicle, refer to the instructions below and also use the images from the video. The actuator is located on the gearbox on the left side when looking at the rear of the car. To dismantle it, you will need a socket spanner to unscrew the three securing bolts and then disconnect the electrical connector.

Next, clean and degrease the actuator by dismantling the joint with a degreasing and lubricating fluid. After this process, you can reassemble everything.


Updated on 23 May 2026 by ScegliAuto


Related tutorials

How to Install the Clutch Actuator on the Smart Fortwo 451
How to Install the Clutch Actuator on the Smart Fortwo 451
Smart (2007-2015 / 451) In today's tutorial video, you will learn how to install the clutch actuator on the Smart Fortwo 451 by following the instructions below. First, lift…
How to Replace the Clutch Actuator on a Smart Fortwo 451
How to Replace the Clutch Actuator on a Smart Fortwo 451
Smart (2007-2015 / 451) To determine if it is necessary to replace the clutch actuator on a Smart Fortwo 451, perform a check on the vehicle. Open the bonnet and remove the …
How to Adjust the Gear Actuator on a Smart ForTwo 451
How to Adjust the Gear Actuator on a Smart ForTwo 451
Smart (2007-2015 / 451) This guide shows how to adjust the gear actuator on a Smart ForTwo 451. This procedure is necessary when the gearbox does not engage reverse. A diagn…

How to Replace the Glow Plugs in the Fiat Ducato 2.3 Multijet?

Glow plugs, as the name suggests, raise the temperature of the engine in diesel vehicles to allow for easier starting. The manufacturer, in this case, Fiat for the Ducato 2.3 Multijet, specifies how often they should be replaced, and a warning light will illuminate when it's time. This work is carried out under the bonnet. First, remove the upper engine cover, then lift the coil and, using a socket wrench of the appropriate size, unscrew the glow plug to remove it from the base, followed by installing the new one.

Watch the video!


by ScegliAuto

More videos