Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Adjust the Gear Actuator on a Smart ForTwo 451

Model: Smart Smart 451 - Years: 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015
Part: Drivetrain

See other generations:
Video tutorial

This guide shows how to adjust the gear actuator on a Smart ForTwo 451. This procedure is necessary when the gearbox does not engage reverse. A diagnostic device is required.

Lift the rear of the vehicle and disconnect the battery, then remove the three E10 bolts and take out the actuator; this component is located on the left side of the engine. Remove the Torx screws from the cover to access the internal part of the actuator.

Clean off the old grease and apply new grease, then refit the component. Now, connect the diagnostic device to the OBD port and perform the actuator relearning procedure.

Once completed, check the correct operation of the transmission.


Updated on 18 June 2026 by ScegliAuto


Related tutorials

How to Install the Clutch Actuator on the Smart Fortwo 451
How to Install the Clutch Actuator on the Smart Fortwo 451
Smart (2007-2015 / 451) In today's tutorial video, you will learn how to install the clutch actuator on the Smart Fortwo 451 by following the instructions below. First, lift…
How to Replace the Clutch Actuator on a Smart Fortwo 451
How to Replace the Clutch Actuator on a Smart Fortwo 451
Smart (2007-2015 / 451) To determine if it is necessary to replace the clutch actuator on a Smart Fortwo 451, perform a check on the vehicle. Open the bonnet and remove the …
How to Replace the Clutch Actuator in a Smart ForTwo?
How to Replace the Clutch Actuator in a Smart ForTwo?
Smart (2007-2015 / 451) In this tutorial, see how to replace the clutch actuator in a Smart ForTwo 451, a simple task if you have good manual skills. First, lift the car on …

Other guides you may be interested in

How to Open the Fuel Filler Flap in the Hyundai i30?

In this tutorial, you will learn how to open the fuel filler flap in the Hyundai i30, a very simple operation that follows the typical procedure of most vehicles. First, unlock the locks using the designated button on the remote, then open the driver's door, locate the release lever on the left side of the seat, and operate it. Next, move to the fuel filler flap, open it completely, unscrew the cap, and refuel as needed. To close the flap, simply press it gently.

Watch the video!


by ScegliAuto

More videos