Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Where is the gearbox actuator located in the Smart ForTwo?

Model: Smart Smart 451 - Years 2007-2015
Part: Transmission

In this video, we can see where the gearbox actuator is located in the Smart ForTwo and how to proceed in case we need to replace it, a very simple operation. As shown, the actuator is located in the lower area of the vehicle, right on the gearbox casing, and is accessible by going under the engine compartment. To remove it, we first lift the rear side of the vehicle, then locate and disconnect the indicated connector. Next, we unscrew the two fixing bolts with an E10 wrench, separate the actuator from the support, and install the replacement if necessary.

Posted on 30 December 2023 by ScegliAuto

Video tutorial

Related tutorials

How to adjust the shift actuator of the Smart ForTwo 451
How to adjust the shift actuator of the Smart ForTwo 451
Smart (2007-2015 / 451) The guide shows you how to adjust the shift actuator on the Smart ForTwo 451. This procedure is necessary when the transmission does not engage rever…
How to remove the gear knob of a Smart ForTwo
How to remove the gear knob of a Smart ForTwo
Smart (2004-2006 / 454, Fourfour1) Before we begin, we will have to sit in the driver's seat of our Smart ForTwo. In order to be able to carry out this disassembly in complete safety, …
How to disassemble the actuator on the Smart Fortwo 451
How to disassemble the actuator on the Smart Fortwo 451
Smart (2007-2015 / 451) If we want to proceed with a revision of the gearbox actuator of our car we can refer to the instructions below and also help us with the images of t…

    Frequently Asked Questions

    • Smart 2014-2021 - What to do when the automatic transmission of the Smart car is not working properly? Read answer
    • Smart 2014-2022 - What are the problems with the automatic transmission of the Smart 453? Read answer

How to Install Roof Bars on a Fiat 500L

Learn how to fit universal roof bars on a Fiat 500L. These bars are used on vehicles with or without roof rails. Assemble the roof bar kit (as shown in the video) with bars adjusted to the width of the vehicle (measure with a tape measure). Position the brackets at both ends of the doors on the vehicle's original roof rails. Once the anchoring bracket width is set, tighten the bolts with a butterfly nut (if a lock is present) until fully secured to the roof rails. Fit safety caps on both sides.

Watch the video!


by ScegliAuto

More videos