Do it yourself
Frequently asked questions about cars and motorcycles

How to Replace the Lift Supports on a Porsche 911

Model: Porsche 911 997 - Years 2005-2011
Part: Hydraulic pistons

How to remove and replace the lift supports for the hood on a Porsche 911? Let's see how to replace them in this video: Lift the hood and secure it. Use a screwdriver or metal lever to detach the clips that hold the lift support at both ends (or unscrew the mounting pins). Install the new part onto the sheet metal of the front trunk, securing the lift support with the clips/pins. Proceed in the same manner for the removal/installation of the opposite lift support. Finally, test the gas springs installed earlier.

Updated on 2 March 2026 by ScegliAuto

Video tutorial

Related tutorials

Porsche 911 (1997-2005 / 996) Start by inserting the tip of a small flathead screwdriver into the key of your Porsche 911 and prying it open. This will expose the dead battery. Pr…
Porsche 911 (1982-1991 / ) How to replace engine oil and filter on Porsche 911? Follow these steps: Open the rear hood and lift it up, secure it, and remove the oil filler cap.…
Porsche 911 (2019-2026 / 992) If you own the beautiful 2022 Porsche 911 and don't know where the box containing all the various fuses of the car is located, don't worry because th…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos