Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Permanently Disable Start & Stop in the Subaru Outback?

Model: Subaru Outback MK 6, BT - Years 2020-2025
Part: Checks and maintenance

In this tutorial, we will see how to permanently disable Start & Stop in the Subaru Outback, a very simple and quick operation to perform if you find it too intrusive. To do this, you will need the device shown in the video, which can be easily found online. First, ensure that the instrument panel is off, then open the upper sunglasses compartment and unscrew the two bolts indicated with an 8mm socket. Next, remove the ceiling light, disconnect the indicated connector, and connect it to the device. Once connected, simply reassemble everything by following the reverse procedure.

Posted on 15 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Steering Wheel and Airbag from the Subaru Outback
How to Remove the Steering Wheel and Airbag from the Subaru Outback
Subaru Outback (2009-2014 / MK 4, BM, BR) Today, we will see in this video tutorial how to remove and replace the steering wheel and its airbag from the Subaru Outback, following the instruct…
How to Reset the Tyre Pressure Warning Light on a Subaru Outback
How to Reset the Tyre Pressure Warning Light on a Subaru Outback
Subaru Outback (2009-2014 / MK 4, BM, BR) Before you begin, exit the cabin of your Subaru Outback. Start by checking and inflating the car's tyres until they all reach the correct pressure. N…
How to Change the Time on a Subaru Outback?
How to Change the Time on a Subaru Outback?
Subaru Outback (2014-2019 / BS, MK 5) Good morning, today’s goal is to modify the time on the onboard computer of your Subaru Outback. Start by sitting in the driver’s seat of the vehicle…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos