Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Wiper Motor on a Subaru Outback?

Model: Subaru Outback MK 4, BM, BR - Years 2009-2014
Part: Windshield wipers

To replace the wiper motor on the vehicle, proceed as follows: first, unscrew the fastening nuts of the wiper arms using a 14 mm spanner and remove them. Next, open the bonnet and detach the clips securing the cover located just below the windscreen. At this point, you will have access to the wiper motors; disconnect the electrical connectors. Then, unscrew the mounting bolts of the motor and its connecting arm. Finally, disconnect the motor from the arm and linkages, and proceed with the replacement if necessary.

Updated on 26 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Reset the Tyre Pressure Warning Light on a Subaru Outback
How to Reset the Tyre Pressure Warning Light on a Subaru Outback
Subaru Outback (2009-2014 / MK 4, BM, BR) Before you begin, exit the cabin of your Subaru Outback. Start by checking and inflating the car's tyres until they all reach the correct pressure. N…
How to Replace the Air Filter on the Subaru Outback?
How to Replace the Air Filter on the Subaru Outback?
Subaru Outback (1999-2003 / MK 2, BH, BE) As shown in this tutorial, replacing the engine air filter on the Subaru Outback is a very simple and cost-effective task. First, to work safely, ens…
Where is the OBD2 Port on the Subaru Outback 5?
Where is the OBD2 Port on the Subaru Outback 5?
Subaru Outback (2014-2019 / BS, MK 5) To access the data from the ECU of your Subaru Outback fifth series, you need to know the exact location of the OBD port to connect a diagnostic tool…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos