Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Brake Replacement and Maintenance

Model: Subaru Outback BP, MK 3, BL - Years 2003-2009
Part: Brake rotors

Remove the bolts behind the brake piston to take it out, along with the pad located at the front. Now, remove the bolts from the fixed part of the brake to disassemble it and gain access to the brake disc, which you can remove by tapping it with a rubber mallet to dislodge it from its corroded position. After checking that the springs and internal shoes are intact, you can fit the new disc. Perform maintenance on the piston and pads to ensure you have a fully functioning brake.

Updated on 23 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the front brake pads of the Subaru Outback MK4
Replacement of the front brake pads of the Subaru Outback MK4
Subaru Outback (2009-2014 / MK 4, BM, BR) Let's see in this video how to remove and replace the front brake discs and pads of the Subaru Outback fourth series, following the instructions belo…
How to Replace Brake Discs
How to Replace Brake Discs
Subaru Outback (1999-2003 / BE, BH, MK 2) The following guide provides useful instructions on how to replace the brake discs on your car. The braking system is of utmost importance to ensure …
Replacement of the Subaru Outback front brake pads
Replacement of the Subaru Outback front brake pads
Subaru Outback (2014-2019 / MK 5, BS) Let's see in this video tutorial how to replace the old brake pads on a Subaru Outback, model produced from 2014 to 2019. To start we lift the car an…

How to Change the Diesel Filter on a Renault Captur 1.5 dCi

The diesel filter on the Renault Captur is always of the immersion type, but instead of being located at the top of the engine bay, it is positioned lower, inside the front right wheel arch (passenger side), practically under the headlamp. To replace it, it is advisable to lift the vehicle, remove the front right wheel and the corresponding inner lining to access the filter location. Unscrew the fastening nuts of the support clamp to extract it from its housing and disconnect the connector and pipes. At this point, unscrew the fixing screws of the cap, remove the old filter and insert the new one, also replacing the O-ring seals, and then reverse the steps for installation. Before starting the engine, turn the ignition on and off several times to allow the filter to fill.

Watch the video!


by ScegliAuto

More videos