Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Front Brake Pads on a Subaru Outback

Model: Subaru Outback BS, MK 5 - Years 2014-2019
Part: Brake pads

This video tutorial shows how to replace the old brake pads on a Subaru Outback, model produced from 2014 to 2019. To start, lift the car and remove the wheel where the work is needed. Now remove the brake caliper by unscrewing the two bolts located behind it, one at the top and one at the bottom. Once removed, retract the two pistons of the caliper, using a press if necessary. After this, remove the brake pad housing using two bolts, then replace the brake pads, reassemble everything, and you have completed the job.

Updated on 12 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Reset the Tyre Pressure Warning Light on a Subaru Outback
How to Reset the Tyre Pressure Warning Light on a Subaru Outback
Subaru Outback (2009-2014 / MK 4, BM, BR) Before you begin, exit the cabin of your Subaru Outback. Start by checking and inflating the car's tyres until they all reach the correct pressure. N…
Where is the OBD2 Port on the Subaru Outback 5?
Where is the OBD2 Port on the Subaru Outback 5?
Subaru Outback (2014-2019 / BS, MK 5) To access the data from the ECU of your Subaru Outback fifth series, you need to know the exact location of the OBD port to connect a diagnostic tool…
How to Change the Time on a Subaru Outback?
How to Change the Time on a Subaru Outback?
Subaru Outback (2014-2019 / BS, MK 5) Good morning, today’s goal is to modify the time on the onboard computer of your Subaru Outback. Start by sitting in the driver’s seat of the vehicle…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos