Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this tutorial, we can see how to replace the front headlight bulbs in the Suzuki SV 650 S, an extremely simple and quick operation. First of all, make sure that the key is not inserted, then locate the plastic panel located on the back of the headlight in question and unclip it with a screwdriver with a flat tip. Next, disconnect the power connector, remove the large rubber cap, and release the metal clip. At this point, we can remove the old bulb from the housing, insert the replacement, and reassemble everything following the reverse procedure.

Posted on 13 January 2025 by ScegliAuto

Video tutorial

Related tutorials

How to replace the headlight bulbs in the Suzuki SV650?
How to replace the headlight bulbs in the Suzuki SV650?
Sv 650 In this tutorial, we will see how to replace the headlight bulbs in the Suzuki SV650, a very simple and quick operation. First, ensure the key is not…
How to Replace the Front Brake Pads of the Suzuki SV 650
How to Replace the Front Brake Pads of the Suzuki SV 650
Sv 650 Let’s briefly go through how to remove and replace the front brake pads of the Suzuki SV 650 motorcycle in simple steps. First, remove the front brak…
Removing the Front Wheel of the Suzuki SV 650
Removing the Front Wheel of the Suzuki SV 650
Sv 650 In this video tutorial, we will see the instructions that will allow us to remove and replace the front wheel of the Suzuki SV 650 in simple and quic…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos