Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Today, you will learn how to remove the front panel of the Suzuki Burgman 650. To remove the panel, use an 8 mm star screwdriver to unscrew the screws located on the plastic part of the dashboard. Unscrew the upper and lower screws, rotating the handlebars for access. After removing the screws, detach the panel by pulling it firmly outward. The installation involves inserting the handlebars and securing the four screws, first the lower ones and then the upper ones. This operation is useful during maintenance of the electrical system or for replacing the panel.

Posted on 3 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Reset the Oil Light on the Suzuki Burgman 650
How to Reset the Oil Light on the Suzuki Burgman 650
Burgman 650 If you have just performed an oil change on your Suzuki Burgman 650 and do not know how to manually reset the related warning light, then this guide …
How to reset the oil warning light on the Suzuki Burgman 650
How to reset the oil warning light on the Suzuki Burgman 650
Burgman 650 If you have just changed the oil on the Suzuki Burgman 650 and still notice the oil warning light is on, do not worry; simply perform the following r…
How to Replace the Fork Oil on a Suzuki Burgman 650
How to Replace the Fork Oil on a Suzuki Burgman 650
Burgman 650 To replace the fork oil on the Suzuki Burgman, first remove the front wheel. Loosen the relevant bolts and slide out the axle. To remove the forks fr…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos