Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Suzuki Gsx R 150
Part: Key

In this video, you will see how to disassemble and replace the key fob battery on a Suzuki GSX-R 150, as well as on the 125. First, take the electronic key fob and pry on the sides to open it into two parts, as shown in the video; this will give you access to the battery and the circuit board. Now remove the old battery and replace it with the new one of the correct type (in this case, a CR 2032 3V); then reassemble the two halves of the fob and check its functionality!

Updated on 2 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Change the Engine Oil in the Suzuki GSX R150
How to Change the Engine Oil in the Suzuki GSX R150
Gsx R 150 Changing the engine oil in the Suzuki GSX R150, as shown in this tutorial, is an extremely simple and quick operation. First, wait until the engine i…
How to Set the Time on the Suzuki GSX-R150?
How to Set the Time on the Suzuki GSX-R150?
Gsx R 150 In this tutorial, you will see how to set the time on the Suzuki GSX-R150, a very simple and quick operation to perform, for example, after disconnec…
How to Replace the Throttle Cable on a Suzuki GSX-R 150
How to Replace the Throttle Cable on a Suzuki GSX-R 150
Gsx R 150 To replace the throttle cable on the Suzuki GSX-R 150, loosen the screws securing the fairing on the left side of the bike, just below the fuel tank.…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos