Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Let’s briefly see how to perform the routine maintenance service by changing the engine oil and oil filter on the Suzuki Bandit 1250. First, place the motorcycle on its centre stand and start by unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then unscrew the oil filter cartridge found behind the exhaust manifold, as shown in the video. Install the new oil filter and finally top up with new oil, pouring in the correct amount!

Updated on 22 June 2026 by ScegliAuto

Video tutorial

Related tutorials

Oil Change on a Suzuki Bandit 1250
Oil Change on a Suzuki Bandit 1250
Bandit 1250 How to change the oil and engine filter on a Suzuki Bandit 1250? Position the motorcycle on the stand; remove the plastic filler cap and use a spanne…
How do you replace the air filter of the Suzuki Bandit 1250?
How do you replace the air filter of the Suzuki Bandit 1250?
Bandit 1250 In order to replace the air filter of the Suzuki Bandit 1250, you need to loosen the screws that secure the motorcycle seat to its housing: once thes…
How do you replace the exhaust pipe of the Suzuki Bandit 1250?
How do you replace the exhaust pipe of the Suzuki Bandit 1250?
Bandit 1250 In order to replace the exhaust pipe of the Suzuki Bandit 1250, you need to loosen the screws that secure the exhaust terminal to its housing, next t…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos