Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Suzuki
  4. :
  5. Vitara
  6. : 1999-2005 (MK 2, FT, GT)

Suzuki Vitara Years 1999-2005 (MK 2, FT, GT)

Suzuki Vitara (1999-2005 / FT, GT, MK 2)
Replacement of the front axle joint of the Suzuki Vitara

Let's briefly see the instructions that will allow us to disassemble and replace the joint and boot of the front driveshaft of the Suzuki Vitara. First, we …read all…
Posted on 13 February 2024 by ScegliAuto
Suzuki Vitara (1999-2005 / FT, GT, MK 2)
How to replace the alternator and its belt on the Suzuki Vitara.

In this video tutorial, we will see how to dismantle and replace the alternator and its belt of the Suzuki Vitara. First, we open the engine hood of our car …read all…
Posted on 14 January 2024 by ScegliAuto
Suzuki Vitara (1999-2005 / FT, GT, MK 2)
How to replace the key battery on Suzuki Vitara

We can see through this short video guide how to replace the internal battery of the remote control of a Suzuki Vitara produced from the year 1999 to the year …read all…
Posted on 29 December 2022 by ScegliAuto
Alternator (1) Antenna (1) Car stereo (3) Roof Rack Bars (1) Battery (3) Gearbox (1) Bodywork (1) Key (9) Timing belt (3) V-belt (1) -board computer (15) Checks and maintenance (52) Headlight (1) Tail light (2) Air filter (1) Cabin air filter (5) Diesel filter (3) Oil filter (1) Hand brake (3) Clutch (1) Side turn signal light bulb (1) Headlight bulb (2) Handle (2) Engine oil (8) Door panel (7) Tires (1) Fuel pump (2) Instrument cluster (19) Wheel (1) Fuse box (10) Drive shaft (1) Outside rearview mirror (1) Windscreen wipers (2)

See also:

How to reset the TPMS light of the Volkswagen Polo 2011

The orange tire light indicates the presence of one or more tires with an inflation pressure below the recommended limit. All this is easily solved by inflating them correctly or replacing them in the event of a puncture. After carrying out these operations it is necessary to reset the warning light and therefore also the sensor in order to have new reading data. All you have to do is start the car ignition and then fully open the glove compartment on the passenger side. Locate the two buttons in the right corner and press "Set". At this point the reset is complete and you can turn off the ignition.

Watch the video!


by ScegliAuto

More videos