Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Before performing a routine service on any scooter or motorcycle, it is advisable to warm up the engine for a few minutes to raise the temperature of the circulating oil and reduce its viscosity: this will facilitate its subsequent drainage. For the same reason, also clear the hole where you will add the new lubricant, located on the right side of the scooter with a black cap marked "oil". Now, unscrew the bolt that acts as the plug for the drainage hole, which is also on the right side of the scooter but underneath the engine compartment. Collect the used oil in a container and add the same quantity from the upper hole.

Updated on 5 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to perform a service on the Sym CruiSym 300
How to perform a service on the Sym CruiSym 300
Cruisym 300 The following steps will guide you through performing the routine maintenance service, replacing the engine oil, oil filter, and air filter on the Sy…
How do you reset the service light on the SYM CRUISYM 300?
How do you reset the service light on the SYM CRUISYM 300?
Cruisym 300 The Sym Cruisym 300 scooter is on par with all other scooters and cars, that is, when the service is due, the warning light in the shape of an Englis…
How to Reset the "Service" Light on a Sym CruiSym
How to Reset the "Service" Light on a Sym CruiSym
Cruisym 300 Before you start, sit on the seat of your Sym CruiSym. Begin by turning on the ignition by turning the key in the ignition switch. Then, repeatedly p…

How to Replace the Battery in a Yamaha Vino 125 Scooter?

In this tutorial, you will see how to replace the battery in a Yamaha Vino 125 scooter, a very simple and quick operation. First, ensure that the key is not inserted for safety. Then, lift the rubber mat and, using a simple cross-head screwdriver, unscrew the two screws securing the plastic cover. Once opened, disconnect both terminals, starting with the negative, and remove the battery from its housing. To fit the replacement, simply follow the reverse procedure.

Watch the video!


by ScegliAuto

More videos