Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Sym Mio
Part: Headlight bulb

In this video tutorial today we can see the whole operation necessary to replace the low beam bulb on a Sym Mio 50i. Let's start by removing the screws of the front shield along the edges of the scooter, behind the wheel arch and behind the front logo and then remove it, first being careful to disconnect the bulb wiring. Once this is done, we remove the rubber cap that protects the low beam bulb and unscrew the tab screw, then lift the tab that holds the bulb in place and finally remove the bulb itself. Finally, we proceed to install a new low beam bulb following the reverse procedure.

Posted on 28 April 2024 by ScegliAuto

Video tutorial

Related tutorials

How to replace the headlight bulb in the Sym Mio?
How to replace the headlight bulb in the Sym Mio?
Mio To replace the headlight bulb in the Sym Mio, you need to unscrew the screws that secure the front fairing: these are located just below the headligh…
How do you replace the rear turn signal bulb of the Sym Mio?
How do you replace the rear turn signal bulb of the Sym Mio?
Mio In order to replace the rear turn signal bulb of the Sym Mio scooter, you need to loosen the screws that secure the rear fairing of the bike: to do t…
How to Reset the "Service" Light on a Sym Mio
How to Reset the "Service" Light on a Sym Mio
Mio Before you start, sit on the seat of your Sym Mio. Activate the instrument panel by turning the key in the ignition. Then, press the right button on …

How to Reset the Engine Oil Light on a Yamaha XMax 250

This short video demonstrates the procedure to reset the engine oil light on a Yamaha XMax 250 scooter. The operation is very simple and quick; first, insert the motorcycle key into the designated slot and turn it to the first position to power on the instrument panel without starting the vehicle. At this point, you will see the light on the display; simply press the "oil change" button located at the centre of the motorcycle's speedometer and hold it until the light stops flashing. The operation will then be complete; to verify success, turn off and then turn on the instrument panel.

Watch the video!


by ScegliAuto

More videos