Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To install the rear brake protection panel on the TM Racing EN 300, you will need to start by loosening the protective nut located at the rear wheel, at the end of the swingarm: once this nut has been removed, you can proceed to position the corresponding fixing flange and then the protection panel itself. At this point, you can fix the panel by inserting the nut that secures the wheel to the center of its seat: you will now need to tighten it properly to ensure that everything works.

Posted on 10 June 2025 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the exhaust pipe of the TM Racing EN 300?
How do you replace the exhaust pipe of the TM Racing EN 300?
En 300 In order to replace the exhaust pipe of the TM Racing EN 300, you need to loosen the screws that secure the panel on the right side of the bike, righ…
How to Replace the Exhaust on the TM Racing EN 300?
How to Replace the Exhaust on the TM Racing EN 300?
En 300 To replace the exhaust on the TM Racing EN 300, loosen the two screws that secure the exhaust to the rear of the bike, located in the designated slot…
How to remove the engine from the TM Racing EN 300?
How to remove the engine from the TM Racing EN 300?
En 300 To remove the engine of the TM Racing EN 300 from its housing, you will need to remove some bulky components, such as the seat, the rear mudguard, an…

Changing the Oil and Filter on the Kawasaki Versys

Here’s how to change the oil and filter on the Kawasaki Versys. Warm up the engine for a few minutes, place the motorcycle on the centre stand, open the filler cap, and remove the drain plug underneath the engine. Place a catch basin under the oil sump, unscrew the drain plug, and let the oil drain out. Unscrew the oil filter and let all the old oil drain out. Install a new filter and tighten it with the appropriate tool. Pour half a glass of new oil into the filler cap and wait for it to flow out of the drain hole, after which replace the plug. Fill with approximately 1.8 litres of new oil, take it for a short ride to circulate the oil in the engine, stop the engine, and check the level through the designated window. Top up if necessary.

Watch the video!


by ScegliAuto

More videos