Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this video, you will see how to make some aesthetic and functional modifications on a Tm Racing SMR 125 motorcycle, following the instructions provided below. First, install the pad on the front wheel; insert it from one side with the entire rod, then tighten it by screwing from the opposite side, as shown in the video. Next, install the cap for the rear brake pump; remove the side fairing and unscrew the screws of the original cap to remove it: then install the new one, reassembling and tightening everything!

Updated on 15 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Front Brake Fluid Reservoir on a TM Racing SMR 125
Smr 125 In this video tutorial, you will learn how to remove and replace the front brake fluid reservoir on a TM Racing SMR 125. First, open the cap of the r…
Replacing the Brake and Clutch Levers on TM Racing SMR 125
Replacing the Brake and Clutch Levers on TM Racing SMR 125
Smr 125 In this video tutorial, we will see how to dismantle and replace the brake and clutch levers on a TM Racing SMR 125 motorcycle. First, remove the clu…
How to Change the Engine Oil on a TM Racing SMR 125?
How to Change the Engine Oil on a TM Racing SMR 125?
Smr 125 To change the engine oil on a TM Racing SMR 125, loosen the drain plug located at the bottom centre of the bike. This will allow all the oil to drain…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos