Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of Rear Headlamp Bulb

Model: Toyota Yaris Xp90 - Years: 2005, 2006, 2007, 2008, 2009, 2010, 2011
Part: Tail light bulb

See other generations:
Video tutorial

Detach the grille on the inner lining of the rear bonnet to access the mounting pins of the rear light: then unscrew the nuts, disconnect the bulb holder connector, and remove the light to place it on a convenient workbench. At this point, disconnect the old bulbs (bayonet fitting) and insert the new ones.

Refit the sponge seal and the headlamp in its housing, tightening the respective nuts from the inside (do not exceed the torque) before reconnecting the plug. Finally, check the operation of the bulbs.


Updated on 5 February 2026 by ScegliAuto


Related tutorials

Replacing the Rear Headlamp Bulb on a Toyota Yaris
Replacing the Rear Headlamp Bulb on a Toyota Yaris
Toyota Yaris (1999-2005 / Xp10) Today, learn how to remove and replace the rear headlamp bulb on a first-generation Toyota Yaris. First, open the boot and remove the plastic side co…
How to Replace the Headlamp Bulb on a Toyota Yaris Hybrid
How to Replace the Headlamp Bulb on a Toyota Yaris Hybrid
Toyota Yaris (2011-2019 / Xp130) To replace the headlamp bulb on the Toyota Yaris Hybrid, open the bonnet to access the components inside the engine bay. Specifically, pull the bulb …
How to Replace the Front Headlamp Bulb on a Toyota Yaris
How to Replace the Front Headlamp Bulb on a Toyota Yaris
Toyota Yaris (2005-2011 / Xp90) To replace the front headlamp bulb on a Toyota Yaris, open the bonnet to access the components inside the engine bay. Locate the circular protective …

How to reset the Service light on a 2019 Jeep Renegade?

The Service light, depicted as a yellow spanner, illuminates as scheduled to remind the driver that it is time for scheduled maintenance. This means that the set mileage has been reached, or the expected time has passed. The procedure involves turning on the instrument cluster, pressing the accelerator three times, and then turning off the ignition. After this, keep the brake pressed, turn the ignition back on, and then turn it off again. Upon the next ignition, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos