Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Engine Oil and Oil Filter Replacement Triumph Bonneville T100 2009-2015

Model: Triumph Bonneville T100
Part: Engine oil

Video tutorial

This guide describes how to replace the engine oil and oil filter on a Triumph Bonneville T100/T120 from 2009 to 2015. Obtain 4 litres of Castrol Power1 SAE 10W40 oil and an HIFLO HF204 oil filter. Position the motorcycle on the side stand.

Start the engine, allow it to reach temperature, and then switch off. Place a container for the used oil underneath the engine. Use a ratchet and a 17 mm socket to remove the oil drain plug located under the engine.

Allow the oil to drain and clean the plug thoroughly. Use a socket wrench to remove the oil filter located under the rear side of the engine.

Lubricate the gasket of the new oil filter and screw it in by hand, then tighten it a turn with the wrench. Refit the oil drain plug.

Open the oil filler cap located on the right side of the crankcase. Pour in 3 litres of oil and start the engine for one minute, then switch off. Check the oil level through the inspection hole located under the crankcase (the manufacturer states 3.5 litres with the oil filter).


Updated on 9 March 2026 by ScegliAuto


Related tutorials

Engine Oil Replacement for Triumph Bonneville T100
Bonneville T100 In this video tutorial, learn how to replace the engine oil on a Triumph Bonneville T100. First, lower yourself and unscrew the oil drain plug: use a…
How to Replace the Oxygen Sensor on the Triumph Bonneville T100
How to Replace the Oxygen Sensor on the Triumph Bonneville T100
Bonneville T100 Briefly follow these instructions to remove and replace the oxygen sensor on the Triumph Bonneville T100 motorcycle. First, place the bike on the cen…
How to Replace the Rear Shock Absorber on the Triumph Bonneville T100?
How to Replace the Rear Shock Absorber on the Triumph Bonneville T100?
Bonneville T100 To replace the rear shock absorber on the Triumph Bonneville T100, you need to loosen the screws that secure it to its housing: these screws will be …

Replacing the Front Brake Pads on the Triumph Daytona 675

The following instructions will allow you to remove and replace the front brake pads on the Triumph Daytona 675. First, place the bike on a stand and begin undoing the fixing screws of the front brake caliper; apply pressure to the caliper piston to retract it, thus removing the old brake pads, as shown in the video. At this point, clean the caliper of any residual dirt, then install the new original brake pads; reattach the caliper to the disc, replacing the other brake pads in the same manner!

Watch the video!


by ScegliAuto

More videos