Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Use 10W40 oil for four-stroke engines. Remove the two screws from the oil filter protection bracket. Start the bike for a couple of minutes to allow the lubricant to become less viscous, facilitating its drainage. Open both the drain hole and the upper fill hole to avoid a vacuum, and collect the used oil in a container. Unscrew the oil filter as shown in the video with the appropriate tool, and clean it before refitting. If you intend to change it, remember to lubricate the O-ring (even with the used oil) before installing the new filter. Close the lower drain hole of the engine oil compartment and add the new oil through the upper hole.

Updated on 30 March 2026 by ScegliAuto

Video tutorial

Related tutorials

Engine Oil Replacement for Triumph Bonneville T100
Bonneville T100 In this video tutorial, learn how to replace the engine oil on a Triumph Bonneville T100. First, lower yourself and unscrew the oil drain plug: use a…
How to disassemble the fuel tank of the Triumph Bonneville T100
How to disassemble the fuel tank of the Triumph Bonneville T100
Bonneville T100 The instructions in this guide will show us the process of disassembling and replacing the fuel tank of the Triumph Bonneville T100 motorcycle. First…
How to Replace the Oxygen Sensor on the Triumph Bonneville T100
How to Replace the Oxygen Sensor on the Triumph Bonneville T100
Bonneville T100 Briefly follow these instructions to remove and replace the oxygen sensor on the Triumph Bonneville T100 motorcycle. First, place the bike on the cen…

How to Replace the Spark Plug on the Sym CruiSym 300

In this short and simple guide, you will learn how to remove and replace the engine spark plug on the Sym CruiSym 300, following the instructions below. First, place your scooter on the centre stand and begin by removing the under-seat compartment to access the upper part of the engine. Then, disconnect the spark plug connector, using a socket wrench with an extension to unscrew and remove it, as shown in the video. At this point, install the new spark plug of the correct type and thread pitch, applying the reverse procedure!

Watch the video!


by ScegliAuto

More videos