Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Today we will explain how to install the Force Master 2 control unit. The control unit on these types of scooters is located in the compartment under the seat. We connect the cable that comes from the injector to the original connector, using the connectors provided in the kit; we connect the control unit to the injectors, respecting the wire colors. We connect the black wire of the control unit to the negative terminal or to a solid ground point on the frame. We locate the TPS connector and, using the wire taps, we connect the control unit wires to the original TPS wires, respecting the colors. After making the connections, we protect the wires and connect them to the ignition coil using the small faston connector. We disconnect and insert the faston into the control unit and connect the original wire via the appropriate bypass; after connecting the control unit to the wiring, we start the scooter. We adjust the idle and maximum by selecting the MAP, using the scooter's throttle buttons.

Posted on 27 December 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Install and Connect the Number Plate Holder with Rear Camera?
How to Install and Connect the Number Plate Holder with Rear Camera?
(Various brands) Various If you want to install the rear camera on the number plate holder along with the parking sensors, you can find instructions on how to connect and mou…
How to Get the Spring of a Flip Key Working Again
How to Get the Spring of a Flip Key Working Again
(Various brands) Various This video shows how to get a flip key spring that no longer works functioning again: first, open the remote with a flat screwdriver; excessive force…
How to fit a wheel cover?
How to fit a wheel cover?
(Various brands) Various A wheel cover serves an important function, contrary to popular belief, as it protects the wheel rim from accidental impacts, such as against a kerb.…

How to Replace the Clutch on a Triumph Speed Triple?

To replace the clutch on a Triumph Speed Triple, loosen the bolts securing the covers of the three casings located on the right side of the bike, namely the starter motor, the engine, and then the clutch. Once these covers are removed, you can access the bolts securing the clutch, unscrew them, and slide the clutch plates out of their housing. This will allow you to insert the new plates into their place, securing everything with the appropriate bolts; finally, reinstall all the casings.

Watch the video!


by ScegliAuto

More videos