Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. (Various brands)
    3. :
  3. Various
    4. : How to replace the rear suspensions in the Kymco Agility 125.

(Various brands) Various - Video tutorial

Model: (Various brands) Various
Part: Suspensions
Operation: How to replace the rear suspensions in the Kymco Agility 125.

In this video tutorial, we can see how it is possible to replace the rear suspensions in the Kymco Agility 125, following a few simple steps: The suspensions are difficult to reach from behind, so we need to remove the battery compartment and inside we will find the pins; then we proceed to remove the 4 screws with a crosshead screwdriver. Once the battery compartment is removed, we need to disconnect the battery. With a tube wrench or a 10mm socket wrench, we need to remove the two screws we see at the bottom. Once all the screws are removed, we pull out the battery compartment and disconnect the relay and fuse holder; at this point, if we shine a flashlight, we can see the suspension pins at the bottom; now we need to remove these pins, and once they are removed, we can install the new shock absorber.


Posted on 1 April 2023 by ScegliAuto

    Frequently Asked Questions

    • Vari - What to do if you have suspension problems with your Scania? Read Answer
    • Vari - What's wrong with the Mercedes Airmatic suspension? Read Answer
    • Vari - How much does a car trapeze cost? Read Answer
    • Vari - How much does a car suspension cost? Read Answer
    • Vari - How much does it cost to replace the swing arm? Read Answer
    • Vari - How do i remove the heads of the suspension wishbones? Read Answer
    • Vari - What problems can the air suspension of my Mercedes run into? Read Answer
    • Vari - Malfunctioning Mercedes airmatic suspension, why? Read Answer

Replace the steering angle sensor on the Volkswagen Golf 5

When the steering angle sensor malfunction warning light comes on, it may need to be replaced as follows: first remove the steering wheel and the lower steering wheel guard by removing the three fixing screws. The steering sensor is located just below the steering column. To release it you need to have a small screwdriver and insert it into the hole on the front, push the screwdriver all the way down until the clips at the bottom are released. Next, pull down on the back of the card containing the sensor and disengage it from the steering column. At that point take the new card and reposition it, after which proceed backwards to reassemble the various components.

Watch the video!


by ScegliAuto

More videos