Do it yourself
Frequently asked questions about cars and motorcycles

How to remove the rear light on a Volkswagen Golf 6

Model: Volkswagen Golf Golf 6, MK 6, 5K1, Golf VI - Years: 2008, 2009, 2010, 2011, 2012
Part: Tail light

See other generations:
Video tutorial

Let's see how to remove the rear light of a Volkswagen Golf VI. We start by opening the trunk, and on the side of the light we want to remove, we take off the inner trunk trim panel, which is usually held in place by some plastic clips. Once the panel is removed, we see the back of the light, with the electrical connector attached; let's disconnect it, and now we see two butterfly plastic screws, which are the fastening of the light to the outside.

Let's unscrew them counterclockwise; it is not necessary to remove them completely, just loosen them; in any case, let's use moderate force, as these plastics may have become brittle over time. Now let's grab the light from the outside and pull it towards us: it is held in place by two alignment pins, so we pull straight towards us. The light is now free.


Posted on 14 January 2026 by ScegliAuto


Related tutorials

Volkswagen Golf (2012-2019 / MK 7, Golf 7, Golf VII) Below we will see the information that will allow us to disassemble and replace the rear taillight and its bulbs of the Volkswagen Golf. First, we op…
Volkswagen Golf (2012-2019 / MK 7, Golf 7, Golf VII) Today we will discover the instructions that will allow us to disassemble and replace the bulbs and the rear light of the Volkswagen Golf. First, we …
Volkswagen Golf (2003-2008 / Golf 5, MK 5, Golf V) The following steps will show us how to disassemble and replace the third brake light and its bulbs on a Volkswagen Golf. First, move to the back and…

How to Replace the Glow Plugs in the Fiat Ducato 2.3 Multijet?

Glow plugs, as the name suggests, raise the temperature of the engine in diesel vehicles to allow for easier starting. The manufacturer, in this case, Fiat for the Ducato 2.3 Multijet, specifies how often they should be replaced, and a warning light will illuminate when it's time. This work is carried out under the bonnet. First, remove the upper engine cover, then lift the coil and, using a socket wrench of the appropriate size, unscrew the glow plug to remove it from the base, followed by installing the new one.

Watch the video!


by ScegliAuto

More videos