Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Third Brake Light in the Volkswagen Passat?

Model: Volkswagen Passat B6, 3C - Years: 2005, 2006, 2007, 2008, 2009, 2010
Part:

See other generations:
Video tutorial

In this tutorial, you can see how to replace the third brake light in the Volkswagen Passat, an extremely simple and quick operation. To do this, you will need a plastic spatula to avoid leaving any marks on the various elements.

First, go to the rear seat, then unclip the headlining panel, being careful not to damage the internal clips. Once removed, grasp the light, pull it towards the outside of the vehicle, and detach it from the support.

Finally, disconnect the power connector and fit the replacement by following the reverse procedure.


Updated on 8 August 2026 by ScegliAuto


Related tutorials

How to disable the Start & Stop feature in the Volkswagen Passat?
How to disable the Start & Stop feature in the Volkswagen Passat?
Volkswagen Passat (2014-2023 / MK 8, 3G, B8) In this tutorial, we will see how to disable the Start & Stop feature in the Volkswagen Passat, a very simple and quick operation to perform, for exa…
How to Reset the "Service" Light on a Volkswagen Passat
Volkswagen Passat (2010-2014 / B7) Before you begin, sit in the driver's seat of your Volkswagen Passat. Insert the electronic key into the designated slot. Next, press and hold the bu…
How to Replace the Air Vents on the Volkswagen Passat
How to Replace the Air Vents on the Volkswagen Passat
Volkswagen Passat (2005-2010 / B6, 3C) To replace the air vents on the Volkswagen Passat, use a thin object as a lever. Insert it into the bottom of the vents to extract them from their ho…

How to reset the Service light on a 2019 Jeep Renegade?

The Service light, depicted as a yellow spanner, illuminates as scheduled to remind the driver that it is time for scheduled maintenance. This means that the set mileage has been reached, or the expected time has passed. The procedure involves turning on the instrument cluster, pressing the accelerator three times, and then turning off the ignition. After this, keep the brake pressed, turn the ignition back on, and then turn it off again. Upon the next ignition, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos