Do it yourself
Frequently asked questions about cars and motorcycles

Model: Yamaha Yzf R6

In this video, you will find step-by-step instructions to remove and replace the ignition barrel on the Yamaha YZF R6. First, remove the side fairing located under the handlebars; then unscrew the ignition system screws to remove it, disconnecting the electrical connector. At this point, unscrew and remove the pin of the ignition barrel, as illustrated in the video; now you can fit the new ignition barrel, securing it properly. Follow the video tutorial to the end for reassembly!

Updated on 16 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Yzf R6 In this short and simple guide, we will see how to disassemble and replace the fuel tank of the Yamaha YZF-R6 motorcycle. First, we put our motorcycl…
Yzf R6 To disassemble the Yamaha YZF R6, you need to loosen the screws that fix the engine block to its housing in the center of the frame. Once the screws …
Yzf R6 Today, we will go through the instructions for removing and replacing the clutch discs on a Yamaha YZF-R6 motorcycle. First, place the motorcycle on …

How to Replace the Engine Oil and Oil Filter on an Aprilia RSV 1000

This short video will show you how to carry out the routine maintenance service by replacing the engine oil and oil filter on the Aprilia RSV 1000 motorcycle. First, place your motorcycle on the centre stand and start by unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then use the appropriate tool to unscrew and remove the oil filter, replacing the cartridge with a new one as shown in the video. Finally, unscrew the filler screw and top up by pouring in the suitable oil for your engine!

Watch the video!


by ScegliAuto

More videos