Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Yamaha Tracer 700
Part: Clock

Let's see through this very short tutorial how to adjust the time of the onboard computer on our Yamaha Tracer 700. Let's start by turning on the vehicle's injection, then press the INFO button until the ODO writing appears along with the total kilometers, then press and hold the TRIP button until the number of hours starts flashing, then press the TRIP button again to change the number of hours. Once done, press the INFO button to move on to the minutes and modify them using the TRIP button, finally press the INFO button again to complete the operation. This tutorial is also valid for the Yamaha MT-07.

Posted on 24 April 2024 by ScegliAuto

Video tutorial

Related tutorials

How do you set the clock on the Yamaha Tracer 700?
How do you set the clock on the Yamaha Tracer 700?
Tracer 700 The clock adjustment of the Yamaha Tracer 700 is done by turning on the instrument panel, inserting the key into the ignition switch: once the panel …
How to Replace the Battery in a Yamaha Tracer 700 GT?
How to Replace the Battery in a Yamaha Tracer 700 GT?
Tracer 700 In this tutorial, you will see how to replace the battery in a Yamaha Tracer 700 GT, a very simple and quick operation. First, ensure that the instru…
How do you replace the battery of the Yamaha Tracer 700?
How do you replace the battery of the Yamaha Tracer 700?
Tracer 700 In order to replace the battery of the Yamaha Tracer 700, you need to loosen the screws that secure the motorcycle seat to its housing: once this has…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos