Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Changing the Engine Air Filter on an Aprilia Sportcity 250 Scooter

Model: Aprilia Sportcity 250
Part: Air filter

Video tutorial

Change the engine air filter on an Aprilia Sportcity 250 scooter. Follow this guide to proceed with the filter change.

Position the scooter on the centre stand; using a screwdriver, unscrew the securing screws of the plastic housing. After removing the securing screws, uncover the cap and remove the air filter.

Install a new one if damaged, or reposition the old one after cleaning it (use an air compressor). Finally, close the air filter housing and tighten the screws on either side.


Updated on 9 March 2026 by ScegliAuto


Related tutorials

Removing the Rear Wheel on the Aprilia Sportcity 250
Removing the Rear Wheel on the Aprilia Sportcity 250
Sportcity 250 In today's tutorial video, you will see the steps to remove the rear wheel from the Aprilia Sportcity 250 scooter, following the instructions below. …
Changing the transmission oil of the Aprilia Sportcity 250 ie
Changing the transmission oil of the Aprilia Sportcity 250 ie
Sportcity 250 Here are the necessary instructions to change the transmission oil of the Aprilia Sportcity 250 ie scooter, following these simple and quick steps. F…
How to remove the front headlight of the Aprilia Sportcity 250
How to remove the front headlight of the Aprilia Sportcity 250
Sportcity 250 Follow these steps to remove and replace the front headlight of the Aprilia Sportcity 250 scooter. First, place your scooter on the centre stand and …

How to Replace the Front Headlamp Bulb on a Suzuki GSX-R 600

Today's instructions will show you the steps to remove and replace the front headlamp bulb on the Suzuki GSX-R 600 motorcycle. First, place the bike on a stand and begin by removing the plastic cover protecting the bulb, located behind the headlamp and the instrument cluster; then disconnect the electrical connector and unclip the metal spring, as shown in the video. At this point, remove and replace the bulb with a new one of the correct type and fitting; then refit the bulb and turn on the ignition to check its operation!

Watch the video!


by ScegliAuto

More videos