Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Brake Fluid on Aprilia RS 125

Model: Aprilia Rs 125
Part: Brake fluid

Video tutorial

As always, secure your Aprilia RS 125 in a stable and safe position to work on it, ensuring the operator's safety as much as possible. It is advisable to take this precaution every time you perform maintenance on any motorcycle.

Now, connect a suitably sized hose to the bleed valve (located on the brake system component at the front wheel). The other end of the hose should drain into a container you have prepared in advance.

At this point, pump the old fluid out of the brake circuit into the container by repeatedly squeezing the brake lever. Be careful not to allow air to remain in the circuit by closing the valve before expelling all the fluid.

Finally, after closing the valve, simply introduce the new fluid into the circuit. And that's it!


Updated on 8 April 2026 by ScegliAuto


Related tutorials

How to Replace the Rear Brake Pump on an Aprilia RS 125
How to Replace the Rear Brake Pump on an Aprilia RS 125
Rs 125 This video shows how to disassemble and replace the rear brake pump on an Aprilia RS 125 in simple steps. First, remove the small chain guard by unsc…
Replacing the Brake Fluid on Aprilia RS 125
Replacing the Brake Fluid on Aprilia RS 125
Rs 125 As usual, before performing any maintenance operations on a motorcycle (or a car), you must secure your motorcycle, in this case, the Aprilia RS 125,…
Performing a Rear Brake System Revision on the Aprilia RS 125
Performing a Rear Brake System Revision on the Aprilia RS 125
Rs 125 In this video tutorial, you will learn how to carry out a revision of the brake system and replace the brake pump and pads on the Aprilia RS 125 moto…

How to Reset the Oil Service Light on the Kymco DownTown 125i

This video shows how to reset the oil maintenance light on the Kymco DownTown 125i. This procedure is necessary after performing an oil change, and it is very simple and quick to carry out. To perform this procedure, start the instrument panel without starting the engine, then press the mode button until you reach the oil maintenance option, after which press the reset button for 5 seconds; the reset will then be successful, and you can restart the instrument panel to verify that the procedure has been completed correctly.

Watch the video!


by ScegliAuto

More videos