Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Rear Brake Pump on an Aprilia RS 125

Model: Aprilia Rs 125
Part: Pump

Video tutorial

This video shows how to disassemble and replace the rear brake pump on an Aprilia RS 125 in simple steps. First, remove the small chain guard by unscrewing the fixing screws; this will also remove the bracket that supports the rear brake pump, as illustrated in the video.

Next, disconnect the hoses from the pump, allowing the brake fluid to drain; it is important to correctly insert the spring of the piston before refilling with new brake fluid. Finally, securely attach the brake pump to the original bracket.


Updated on 16 April 2026 by ScegliAuto


Related tutorials

Performing a Rear Brake System Revision on the Aprilia RS 125
Performing a Rear Brake System Revision on the Aprilia RS 125
Rs 125 In this video tutorial, you will learn how to carry out a revision of the brake system and replace the brake pump and pads on the Aprilia RS 125 moto…
How to Replace the Front Brake Disc on an Aprilia RS 125
How to Replace the Front Brake Disc on an Aprilia RS 125
Rs 125 Discover the main steps in this guide that will allow you to remove and replace the front brake disc, as well as the pads, on the Aprilia RS 125. Fir…
Replacing Brake Fluid on Aprilia RS 125
Replacing Brake Fluid on Aprilia RS 125
Rs 125 As always, secure your Aprilia RS 125 in a stable and safe position to work on it, ensuring the operator's safety as much as possible. It is advisabl…

How to Change the Engine Oil on a BMW R1200T?

To change the engine oil on a BMW R1200T, follow these steps. Ensure the bike is on a level surface and the engine is warm but not too hot. Remove the oil filler cap and the oil drain plug, usually located on the underside of the engine. Position a collection container under the drain plug and unscrew it to fully drain the used oil. Once drained, remove and replace the oil filter, ensuring to clean the mounting surface thoroughly. Install the new filter and screw the oil drain plug back in. Fill the engine with new oil through the filler cap until reaching the recommended amount, checking the level with the dipstick if necessary. Secure both caps tightly. Start the engine for a few minutes to circulate the new oil, then turn it off, and the replacement is complete.

Watch the video!


by ScegliAuto

More videos