Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Front Headlight Bulb on the Aprilia Scarabeo 400

Model: Aprilia Scarabeo 400
Part: Headlight

Video tutorial

This guide shows how to replace the front headlight bulb on the Aprilia Scarabeo 400 scooter. After securing the vehicle, use a cross-head screwdriver to unscrew the screw located under the headlight and remove the finishing frame and the upper headlight cover.

Using a 4 mm hex key, unscrew the two fixing bolts of the headlight assembly. Disconnect the electrical cable and, after removing the rubber protective cap from the bulb holder, take out the bulb to be replaced and fit the new one. Reassemble everything in position and check the correct operation before hitting the road.


Updated on 29 May 2026 by ScegliAuto


Related tutorials

How to Replace the Battery of the Aprilia Scarabeo 400?
How to Replace the Battery of the Aprilia Scarabeo 400?
Scarabeo 400 To replace the battery of the Aprilia Scarabeo 400, open the under-seat compartment to access the plastic cover at its base: beneath this cover, you …
How to replace the air filter of the Aprilia Scarabeo 400?
How to replace the air filter of the Aprilia Scarabeo 400?
Scarabeo 400 To replace the air filter of the Aprilia Scarabeo 400, you need to loosen the screws that secure the cover containing the air filter, located on the …
How to Replace the Front Fork Oil on an Aprilia Scarabeo 400
How to Replace the Front Fork Oil on an Aprilia Scarabeo 400
Scarabeo 400 Today, we will go through the step-by-step instructions on how to disassemble the forks and replace the oil on the Aprilia Scarabeo 400 scooter. Firs…

How to Replace the Suspension Spring on a Husqvarna FC 450

Today, we will see the instructions that will allow you to dismantle and replace the suspension spring of the Husqvarna FC 450 enduro bike. First, position the bike on a stand and start disconnecting the rear swingarm from the suspension by unscrewing the lower pin and disconnecting the linkage; this will allow you to work on the suspension by unscrewing the collar to remove the spring, as shown in the video. At this point, install the new suspension spring, compatible with the original; reassemble the suspension and rear swingarm, following the video tutorial to the end!

Watch the video!


by ScegliAuto

More videos