Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the fog light bulb of the 2015 Audi Q5

Model: Audi Q5 8R, MK 1 - Years 2008-2017
Part: Headlight bulb

If one of the two fog light bulbs located in the lower part of the front bumper of your Audi Q5 (2015) has stopped working, then simply read the following guide carefully to understand how you can replace it by yourself and in total safety. First, remove the plastic cover with your own hands, then use a crosshead screwdriver to unscrew the screws that hold the fog light firmly in place. Next, disconnect the electrical connector from the bulb holder and proceed with replacing the faulty bulb with a new one of the same type.

Posted on 4 May 2025 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the rear fog light bulb of the Audi Q5
Replacement of the rear fog light bulb of the Audi Q5
Audi Q5 (2008-2017 / 8R, MK 1) Below we will see the instructions that will allow us to disassemble and replace the rear bumper light bulb (fog light) of the Audi Q5. First of all,…
How to turn on the automatic headlights on an Audi Q5?
How to turn on the automatic headlights on an Audi Q5?
Audi Q5 (2017-2025 / MK 2, 80A) To activate the automatic headlights on your Audi Q5, follow these steps. Start by turning on the car and wait for all systems to start up correctly.…
Where are the fuses of the Audi Q5 located?
Where are the fuses of the Audi Q5 located?
Audi Q5 (2008-2017 / 8R, MK 1) Every fuse of the Audi Q5 is positioned inside one of the specific fuse boxes that are installed on the vehicle: in this type of vehicle, it is possi…

Other guides you may be interested in

How to Replace the Cabin Fan Resistor on a BMW 3 Series

How to Replace the Cabin Fan Resistor on a BMW 3 Series. Open the door and remove the plastic cover under the dashboard on the right side. Use a trim tool to pry off the cover next to the dashboard. Get a screwdriver or a cordless drill, open the glove compartment, and unscrew the fastening screws around the perimeter with a screwdriver. Once this is done, pull out the glove compartment and disconnect the power cables. Remove the fan resistor from its housing, insert the new part into the filter holder, and reassemble all the components of the glove compartment as you disassembled them earlier.

Watch the video!


by ScegliAuto

More videos