Do it yourself
Frequently asked questions about cars and motorcycles

Installation of Projector Headlight and Xenon Kit

Model: Audi A4 B6 - Years 2000-2004
Part: Headlight

You can purchase not only xenon bulbs in the aftermarket but also the projector that will give the headlight, in addition to better efficiency, an appearance comparable to the original. You will need to completely disassemble the headlight, separating the front lens from the plastic housing: it is recommended to heat the headlight by placing it in a box and using a hairdryer to blow warm air. Once the headlight is heated, remove the metal clips along the edge of the glass and detach it. Then, remove the bulb's protective cover and insert the projector, securing it with the rear ring; insert the bulb holder and glue the chrome cover of the projector. Thoroughly clean the inside of the headlight, apply the new gasket along the edge, place the lens, and heat the headlight again to ensure better adhesion of the gasket; finally, reapply the metal clips. Next, proceed to the electrical connections and secure the xenon bulb by inserting the appropriate grommet through the cap of the bulb holder.

Updated on 6 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Audi A4 (2000-2004 / B6) This guide shows how to install an aftermarket xenon headlight kit. Provided that the installation complies with legal requirements set by traffic re…
Audi A4 (2007-2016 / B8) To replace the xenon bulbs in the Audi A4 B8, you must remove the entire headlight assembly. Start by lifting the hood and loosening the four screws …
Audi A4 (2007-2016 / B8) This brief procedure will show you how to remove and replace the headlight bulb on an Audi A4, following the instructions below. First, open the hood…

How to Reset the Central Locking of the Volkswagen Golf 4?

If the central locking system of the Volkswagen Golf 4 is not working, it is likely necessary to reset the system: to do this, open the driver's door and detach the side panel of the dashboard next to the steering wheel. Under this panel, you will find the fuses, including the one for the central locking, which is indicated in the manual as number 14. To reset the system, remove this fuse from its housing, then reinsert it or replace it with a new one of the same amperage: this will reset the central locking system.

Watch the video!


by ScegliAuto

More videos