|
Do it yourself
| |||
| ||||
Change Automatic Transmission Fluid and Filter
Model: Audi A4
B6
- Years 2000-2004
To change the fluid in the automatic transmission, first raise the car on a lift. Unscrew the small drain plug for the fluid. Next, remove the pan by unscrewing all the screws around it. Once the pan is off, remove the filter. Clean the pan, paying attention to the six magnets inside that attract any metallic debris and prevent it from circulating with the fluid. Reposition the magnets and the gasket (which should not be rubber) using special spray. Reinstall the filter and then the pan, initially screwing in all the screws, then tightening them evenly, alternating from one side to the other. Now add the appropriate type of fluid, about five and a half quarts. Then unscrew the larger plug on the pan and insert the pump nozzle. Pump about 3/4 of the fluid until it starts to overflow. At this point, start the car so the pump can circulate the fluid. Check the temperature, which should be around 104-113°F for optimal level, and test all gear positions. Car model: Audi A4 2.8 Year: 2001
Required tools: fluid pump, Torx wrenches T27, T40.
Updated on 10 February 2026 by ScegliAuto
Video tutorial
Related tutorials
Audi A4
(2014-2024 /
B9)
In this video tutorial we will see the steps that will allow us to replace the automatic gearbox oil of the Audi A4, following the instructions below…
Audi A4
(2014-2024 /
B9)
In this guide, we will see the main instructions useful for replacing the automatic transmission oil of the Audi A4. First, we lift the vehicle and s…
Audi A4
(2007-2016 /
B8)
In this guide, we will see the main instructions that will allow us to carry out the adaptation of the multitronic automatic gearbox of the Audi A4. …
Other guides you may be interested in
|
How to Remove the High-Pressure Fuel Pump on VW Golf
In this video, learn how to remove the high-pressure fuel pump on the Volkswagen Golf. Lift the bonnet and secure it, then remove the engine soundproofing panel. Using a screwdriver, unscrew the locking pins of the ventilation pipe and remove the piece from the engine bay. Start removing the fastening pins of the pump as shown in the video. Once the piece is detached from its seat, disconnect the clip present on it. Finally, refit the high-pressure fuel pump in the engine bay, along with the intake pipe and the soundproofing panel. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.059
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |