|
Do it yourself
| |||
| ||||
Audi A4 automatic gearbox oil change
Model: Audi A4
B9
- Years 2014-2024
In this video tutorial we will see the steps that will allow us to replace the automatic gearbox oil of the Audi A4, following the instructions below. First of all we lift the car and start by unscrewing the gear oil vent bolt, which we find right on the transmission; after that we put our gearbox in parking mode and we go to insert the new gear oil with a pump, connecting a pipe on the filling hole, as shown in the video. The amount of oil to be put on our automatic transmission is indicated in the use and maintenance booklet!
Posted on 27 March 2022 by ScegliAuto
Video tutorial
Related tutorials
Audi A4
(2014-2024 /
B9)
In this guide, we will see the main instructions useful for replacing the automatic transmission oil of the Audi A4. First, we lift the vehicle and s…
Audi A4
(2007-2016 /
B8)
In this guide, we will see the main instructions that will allow us to carry out the adaptation of the multitronic automatic gearbox of the Audi A4. …
Audi A4
(2014-2024 /
B9)
It will be possible to perform the reset procedure for the automatic transmission of the Audi A4 by turning on the instrument panel with the ignition…
Other guides you may be interested in
|
How to Replace the Front Headlamp Bulb on a Fiat Grande Punto
To replace the front headlamp bulb on a Fiat Grande Punto, first open the bonnet. Once done, access the rear of the headlamp where the bulb needs replacing (the bulb is of type H4). Locate the rubber cover that protects the electrical contacts and bulbs from water and moisture. Remove it by pulling on the tab. Now, pull the connector for the bulb's power supply and disconnect it from its position. At this point, push down on the top of the spring that holds the bulb in place, and you can extract the bulb from its housing. To fit the new bulb, follow the steps in reverse as shown in the images. The video also shows how to remove the position bulb, which is located just below the H4. After disconnecting the power supply, you can extract it along with the bulb holder by pressing the two tabs to release it and pulling. The bulb can then be removed from its position in the bulb holder. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.056
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |