Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Rear Brake Light Bulb on an Audi A3

Model: Audi A3 MK 2, 8P - Years 2003-2013
Part: Tail light bulb

To replace the brake light bulb of the rear lamp, you must first remove the lamp: once the rear bonnet is opened, locate the caps on the inner lining of the boot that correspond to the lamp's housing. After removing the caps, access the plastic nuts that secure the lamp to the body, which can be unscrewed with a screwdriver or a 10 mm socket. After removing the fixing screws, take out the lamp from its housing and disconnect the lamp holder to replace the bulb (bayonet fitting).

Updated on 22 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the rear headlight bulb of the Audi A3
How to replace the rear headlight bulb of the Audi A3
Audi A3 (2003-2013 / MK 2, 8P) Today we will explain how to replace the rear headlight bulb of an Audi A3 MK2 model car. First, open the trunk of the car and then remove the side a…
How to Remove the Rear Light of an Audi A3
How to Remove the Rear Light of an Audi A3
Audi A3 (2012-2019 / 8V, MK 3) To remove the rear light of an Audi A3 model 8V, follow these steps: - open the boot; - remove the side cover; - unscrew the two Torx screws; - pull …
How to Replace the Xenon Bulb in an Audi A3?
How to Replace the Xenon Bulb in an Audi A3?
Audi A3 (2003-2013 / MK 2, 8P) In this video tutorial, you can see how to replace a xenon bulb in an Audi A3. This is a simple operation and no tools are required. First, disconnec…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos