Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Battery Replacement for Benelli TNT 125

Model: Benelli Tnt 125
Part: Battery

Video tutorial

In this video tutorial, you will learn how to remove and replace the battery of a Benelli TNT 125 in a few simple steps. First, remove the screw from the plastic side fairing to access the battery compartment, where you will need to remove the screws securing the two terminals (positive and negative).

At this point, remove the battery and replace it with the correct new one; insert it in the correct orientation and secure the two terminals. Now, refit the plastic side fairing by tightening the screw, and finally, reattach the seat to complete the job!


Updated on 1 April 2026 by ScegliAuto


Related tutorials

How to Reset the Engine Light on a Benelli TNT 125
How to Reset the Engine Light on a Benelli TNT 125
Tnt 125 Before you can begin, sit on the seat of your Benelli TNT 125. Start by activating the instrument panel by turning the key in the ignition switch, th…
Battery Replacement on the Benelli TNT 125
Battery Replacement on the Benelli TNT 125
Tnt 125 Today, in this tutorial video, learn how to remove and replace the battery on a Benelli TNT 125 motorcycle, following these simple steps. First, remo…
How to Change the Ignition Fuse on the Benelli TNT 125
How to Change the Ignition Fuse on the Benelli TNT 125
Tnt 125 In today's video tutorial, you will see how to remove and replace the ignition fuse of the Benelli TNT 125 motorcycle. First, remove the seat of your…

Vespa Immobiliser: How to Transfer the Chip from the Old Key

In the case shown in the video, the new keys are not recognised by the ECU: the Vespa starts but does not run (thus the immobiliser is active). The solution shown in the video involves locating the immobiliser chip in the old key (the one recognised by the ECU). Open the cover on the key (only red master keys or some blue ones), remove the chip (which is a small black cylinder or rectangle), insert it into the new key in place of the new one, and try to start. Now the key will work. If the master key is red, it will definitely work. If it is blue, it might work: you need to cut the silicone; this is possible but a delicate operation. If it is a black clone key, then it is a system that does not work.

Watch the video!


by ScegliAuto

More videos