Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Benelli Tnt 1130
Part: Wheel

In this video tutorial, you will learn how to remove and refit the front wheel on a Benelli TNT 1120 in simple and quick steps. First, position the front stand on your bike to lift the wheel; then, unscrew the fixing bolts of the front brake calipers as shown in the video. At this point, loosen the two bolts on the fork and then remove the central axle of the wheel using a ratchet spanner; simply extract the front wheel and apply the reverse procedure for reassembly!

Updated on 20 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Rear Wheel of the Benelli TnT 1130?
How to Remove the Rear Wheel of the Benelli TnT 1130?
Tnt 1130 To replace the rear wheel of the Benelli TnT 1130, you need to loosen the central axle that secures the wheel to the swingarm and also the smaller sc…
How do you replace the exhaust pipe of the Benelli TnT 1130?
How do you replace the exhaust pipe of the Benelli TnT 1130?
Tnt 1130 It will be possible to replace the exhaust of the Benelli TnT 1130 by loosening the screws that fix the exhaust terminal to its housing, next to the …
How to Replace the Front Brake Discs of the Benelli TnT 1130?
How to Replace the Front Brake Discs of the Benelli TnT 1130?
Tnt 1130 To replace the front brake discs of the Benelli TnT 1130, first loosen the brake calipers connected to the discs by loosening the appropriate securin…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos