Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Benelli
    3. :
  3. 302r
    4. : How to replace or clean the air filter on Benelli 302R

Model: Benelli 302r
Part: Air filter
How to replace or clean the air filter on Benelli 302R

In this video tutorial we will see how to disassemble and replace (or just clean) the engine air filter on the Benelli 302 R motorcycle, in simple steps. First of all, let's remove the passenger seat, and then remove the driver's seat as well; then we go to unscrew all the fixing screws of the fuel tank, in order to remove it. At this point we can remove the cover of the air filter box; we then extract the air filter, replacing it with the new one. So we just have to reassemble everything, applying the reverse procedure!


Posted on 6 March 2024 by ScegliAuto



How to change the engine oil of a Benelli 302R?
302r To change the engine oil of your Benelli 302R, place the motorcycle on a flat and cold surface. Lift the motorcycle, remove the oil drain plug and le
How do you change the Benelli 302R engine oil?
302r In order to replace the Benelli 302R engine oil, you need to unscrew the oil tank drain plug located in the lower part of the bike, in correspondence

How to change the Royal Enfield Himalayan engine oil and filter

The guide shows you how to change the Royal Enfield Himalayan engine oil and oil filter. The first operation to perform is to secure the vehicle and turn it on to make the oil fluid. At this point, after having placed protection against splashes under the bleed valve and having prepared a container for the disposal of used oil, with a 22 mm wrench, open the valve. Using an 8 mm wrench, remove the fixing bolts of the inspection hatch of the mesh filter and extract the latter. Refit the clean filter and close the door; install the gasket on the purge valve and tighten it in place. On the opposite side of the vehicle, unscrew the three 8 mm bolts and drain the oil from the filter. Remove the old cartridge and clean the housing. Pour some oil into the new cartridge to facilitate the circulation of the oil. Put everything back in place. Fill the tank to the correct level and run the engine for a few minutes. Check the level again and top up if necessary.

Watch the video!


by ScegliAuto

More videos