|
Do it yourself
| |||
| ||||
How to Change the Transmission Oil of the Beta Evo
Model: Beta Evo
Video tutorial
In today's tutorial video, you will learn how to replace the engine oil of the Beta Evo, following the instructions below. First, place the motorcycle on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then, clean the small magnet found on the bolt, as shown in the video. At this point, remove the filler cap and pour in the correct type of new transmission oil, adding approximately one litre into the crankcase.
Updated on 15 May 2026 by ScegliAuto
Related tutorials
Evo
This guide provides instructions for replacing the transmission oil in the Beta Evo 300 motorcycle. First, place the motorcycle on a stand and begin …
Evo
To replace the clutch on a Beta Evo, loosen the circular cover located on the lower central part of the left side of the bike. Once the screws of the…
Evo
To replace the clutch on the Beta Evo, you need to remove the circular cover located at the bottom centre of the left side of the bike. Once the fixi…
|
How to Reset the Service Light on a Vespa Sprint 150?
To reset the Service light on a Vespa Sprint 150, insert the ignition key into the corresponding lock. Once turned to activate the instrument panel, press and hold the button located on the right side of the handlebars. Wait a few seconds with the button pressed until the Service light disappears from the instrument panel. Once the light has been reset, release the button and turn off the ignition by turning the key. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.098
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
