Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Bmw R1200 GS
Part: Brake pads

The following steps will illustrate the procedure for removing and replacing the rear brake pads of the BMW R1200 GS motorcycle. First, place the motorcycle on a stand and begin unscrewing the mounting screws of the rear brake caliper; apply pressure to the piston to retract it, thus removing the old brake pads. At this point, clean the caliper of any residual dirt, then install the new original brake pads; reassemble the brake caliper onto the disc, inserting the locking pin and completing the replacement operation!

Posted on 25 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the front brake pads of the BMW R 1200 GS?
How do you replace the front brake pads of the BMW R 1200 GS?
R1200 GS It will be possible to replace the front brake pads of the BMW R1200 GS by loosening the screws that secure the caliper to its disc: then you will ne…
How do you replace the exhaust pipe of the BMW R 1200 GS?
How do you replace the exhaust pipe of the BMW R 1200 GS?
R1200 GS To replace the exhaust of the BMW R 1200 GS, you need to loosen the screws that hold it to its housing: this will be located next to the rear wheel o…
How do you replace the clutch of the BMW R 1200 GS?
How do you replace the clutch of the BMW R 1200 GS?
R1200 GS It will be possible to replace the clutch of the BMW R1200 GS by loosening the screws that secure the rear part of the frame to its housing: in this …

How to Replace the Front Headlight on the BMW F800GS

In this tutorial, you will see how to replace the front headlight on the BMW F800GS, an extremely simple and quick operation. First, ensure the key is not inserted for safety, then locate the power connector at the back of the headlamp and disconnect it by pressing the clip. Next, unscrew the two side bolts using a Torx T40 key, grasp the headlight and pull it away from the support. At this point, you can insert the replacement, tighten the two bolts, and reconnect the power connector.

Watch the video!


by ScegliAuto

More videos