Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Citroen
    3. :
  3. C3
    4. : How to replace the starter motor of the Citroen C3.

Citroen C3 - Video tutorial

Model: Citroen C3 SC - Years 2009-2016
Part: Starter motor
Operation: How to replace the starter motor of the Citroen C3.

Below we will see the steps that will allow us to disassemble and replace the starter motor of the Citroen C3. First, we open the engine hood and start by disconnecting the battery terminals as a precaution; then we lift the car to access the starter motor, as shown in the video. At this point, we use a ratchet wrench to unscrew the fastening screws of the starter motor, disconnect the electrical connector to remove it; we replace it with the new one and install the new original starter motor, applying the reverse procedure!


Posted on 10 December 2023 by ScegliAuto

    Frequently Asked Questions

    • C3 2009-2016 - Why does the Citroen C3 not start? Read Answer
    • C3 2009-2016 - Where is the starter motor of the Citroen C3 located? Read Answer
    • C3 2002-2009 - What problems does the starter motor of the Citroà «n C3 have? Read Answer
    • C3 2009-2016 - What problems with the starter motor of the Citroen C3? Read Answer
    • C3 2016-2023 - How much does it cost to replace the starter motor on the Citroà «n C3? Read Answer
    • C3 2002-2009 - Where is the starter motor of a Citroen C3 located? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos