Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Starter Motor on the Citroen C3

Model: Citroen C3 FC, FN - Years 2002-2009
Part: Starter motor

Find the information below on how to replace the starter motor on this vehicle. First, open the bonnet and disconnect the battery cables, then remove the battery from its housing and also detach the support base. At this point, you will have access to the starter motor from above and can remove the upper bolt. Once done, lift the vehicle and remove the remaining bolts from underneath, then disconnect the two power terminals, allowing you to extract the starter motor from its position. Take the new starter motor and position it, then proceed to refit all the bolts and reconnect the terminals.

Updated on 7 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Clutch Replacement for Citroen C3 1.6 HDI (MK1)
Clutch Replacement for Citroen C3 1.6 HDI (MK1)
Citroen C3 (2002-2009 / FC, FN) This video provides step-by-step instructions for dismantling and replacing the clutch on the Citroen C3 1.6 HDI, first series. Lift the vehicle and …
How to Replace the Starter Motor on the Citroen C3
How to Replace the Starter Motor on the Citroen C3
Citroen C3 (2009-2016 / SC) Follow the steps to remove and replace the starter motor on the Citroen C3. First, open the bonnet and disconnect the battery terminals. Then, raise …
Replacing the Fuel Filter on a Citroen C3
Citroen C3 (2002-2009 / FC, FN) Replacing the fuel filter on a Citroen C3? Let's look at the disassembly of the part. Lift the bonnet and secure it. Once you locate the fuel filter,…

Other guides you may be interested in

    Frequently Asked Questions

    • C3 2009-2016 - Where is the starter motor of the Citroen C3 located? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos