Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install a Second Courtesy Light in the Boot of the Cupra Formentor?

Model: Cupra Formentor MK 1 - Years: 2020, 2021, 2022, 2023, 2024, 2025, 2026
Part: Checks and maintenance

Video tutorial

This video demonstrates how to increase the brightness of the boot area by installing a second light in the designated fitting. After confirming the light is suitable, prepare an electrician's probe to run the electrical cable under the upholstery, reaching the other light to which you will connect it, securing it with insulating tape.

Once completed, use insulating tape to secure the cable under the carpet to prevent damage, and test the installation.


Updated on 15 September 2026 by ScegliAuto


Related tutorials

How to reset the Service light on the Cupra Formentor?
How to reset the Service light on the Cupra Formentor?
Cupra Formentor (2020-2026 / MK 1) To reset the Service light on the Cupra Formentor, press and hold the OK button located on the right side of the steering wheel. Continue to hold the…
How to Replace the Front Wiper Blades on a Cupra Formentor
How to Replace the Front Wiper Blades on a Cupra Formentor
Cupra Formentor (2020-2026 / MK 1) Today, we will go through the steps to remove and replace the front wiper blades on a Cupra Formentor. First, get in the vehicle and turn on the igni…
How to Reset the Tyre Pressure Light on a Cupra Formentor
How to Reset the Tyre Pressure Light on a Cupra Formentor
Cupra Formentor In this brief and simple video tutorial, learn how to reset the tyre pressure on a Cupra Formentor. Start by pressing the ignition button to turn on …

How to reset the Service light on a 2019 Jeep Renegade?

The Service light, depicted as a yellow spanner, illuminates as scheduled to remind the driver that it is time for scheduled maintenance. This means that the set mileage has been reached, or the expected time has passed. The procedure involves turning on the instrument cluster, pressing the accelerator three times, and then turning off the ignition. After this, keep the brake pressed, turn the ignition back on, and then turn it off again. Upon the next ignition, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos